60 keyboard layout ducky1/7/2024 One option would be to replace them with non-specific blank key caps of the correct profile, which I might end up doing. You can buy completely flat profile keys, such as DSA, or get some other profile keys to match instead. That means these keys might not stand flush with others in the same row due to the key profile. Del, page up, page down, and end keys are usually spread across two horizontal rows on a normal layout board, yet on this board they're across four horizontal rows. The only other issue I have that you'll want to consider if buying a kit for this board is the row of keys down the right-hand side. ❌ You want the cheapest mechanical: It's probably pretty obvious but you could spend a whole lot less on a mechanical keyboard and still get an impressive keeb. These Novelias also come with a see-through plastic housing on the south side of the switch for RGB LEDs to shine through. The NovelKeys Novelias switches I've got at hand for this build fit a gasket mount keyboard such as this, and you'll need to check compatibility for any others you might use with it. Admittedly I quite like the job of plugging in switch after switch into a hot-swappable keyboard-careful not to snap any pins in the process-but it's not for everyone. The next bit, however, is the most repetitive part of the build: switches and caps. Slot the innards into the outer metal frame, screw everything down, and I've pretty much made a mechanical keyboard from scratch. Once that's sorted, I attached the included USB connector to the PCB and got ready to assemble it all together. I've settled on the FR4 for this build, though it's worth noting the white POM plate will likely help the RGB LEDs included on this keyboard shine a bit brighter behind the caps.Ī couple of spacers are required here before slotting the sound dampening foam between it and the PCB and firmly screwing it down.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |